Opening hours:24/7 emergency call-outsOffice visits by arrangement

ASAP Flat Roofing Specialist
Rubber flat roofs

EPDM Rubber Roofing in South East London & Kent

EPDM is a synthetic rubber membrane that goes on as a single sheet.

Read more

On most domestic roofs that means no joints at all, which removes the most common reason flat roofs leak.

We fit EPDM rubber roofing on dormers, extensions, garages and porches across South East London and Kent. It is flexible, copes well with hot summers and cold winters, and is a cleaner install than torch-on felt because it is bonded rather than heated.

Get your free flat roof quote

A few quick details. No obligation, no charge for the visit.

25 year guarantee on qualifying new flat roofs · Fully insured · Owner in the trade since 1987

01

Where EPDM works best

Rubber roofing is a good fit for:

  • Loft dormers, where a single sheet avoids joints on a small, exposed roof
  • Roofs close to timber, plastic or other materials where a torch is not ideal
  • Extensions and garages with simple shapes
  • Roofs that see big swings in temperature
Get my free quote
GRP flat roof sealed neatly against a slate roof
02

How we fit it

We strip the old covering, check and replace any soft decking, then bond the EPDM membrane to the prepared deck.

Read more

New trims go on at every edge and upstands are dressed and sealed. The finished roof is clean, flexible and quiet in the rain.

Not sure if rubber is right for your roof? We will compare it with GRP fibreglass and felt and tell you honestly which makes sense.

Felt flat roof finished against a tiled pitched roof
03

EPDM roofs in your area

We fit EPDM on the loft dormers that are common on the Victorian streets of Forest Hill and Blackheath, and on extensions and garden rooms around Chislehurst.

Get my free quote
Finished grey GRP flat roof over a garden extension
04

Cost of EPDM rubber roofing

EPDM typically costs £70 to £140 per square metre. A dormer of about 10 m² usually comes in between £700 and £1,400.

Read more

The quote is free and in writing, there is no deposit, and you pay when the job is done. See how we work on our home page.

Roll of torch-on felt ready to lay on a flat roof

Common questions

  • Neither is better for every roof. EPDM has no joints and is flexible; torch-on felt is very tough and cost-effective. We will recommend the right one for your roof.

Leaking flat roof? Get it sorted properly.

Get my free quote
Call nowFree quote